Skip to main content

Side-Emitting LED Neon Flex

Side-emitting LED neon flex directs light from a vertical face of the profile. Coordinate the face orientation, installation outline and profile dimensions before selecting an LED configuration.

Explore ProfilesRequest a Quote
Side-Emitting LED Neon Flex catalogue photograph
Family photograph from the AlisterTech International Catalogue. Configuration must be selected separately.

How Do I Choose a Side-Emitting LED Neon Profile?

Identify the vertical face that must remain visible, then check the available profile width and height. Show the curve, corners, cable exits and mounting route on your drawing. Choose the electrical and colour configuration from the exact catalogue row, rather than transferring specifications from another section. Emitting direction and bending direction are different decisions: confirm the permitted bending plane and route for the quoted assembly before installation.

Compare the Profile Sections

These are representative catalogue sections, not model names created from dimensions. The pictured geometry and the exact electrical configuration are separate parts of selection.

Catalogue-based enhanced illustration of AlisterTech 12 x 20 mm silicone profile, showing source outer dimensions

Illustrative rendering; confirm internal details with the selected sample.

12 x 20 mm

Catalogue page 13, profile 7

Review catalogue row

Profiles & LED Configurations

Choose the geometry first, then compare the configuration rows for that profile. Voltage, power, luminous flux and cut length are not interchangeable across variants.

The slim 4 x 10 mm profile below lists 24 V single-colour, tunable-white and RGB configurations. For a 12 V LED neon flex requirement, review the Pixel RGB row of the 6 x 12 mm profile; its single-colour and RGB rows are 24 V. Compare the exact colour and control requirement before selecting a supply or transferring cutting details between variants.

For the separately listed compact format, see 4 × 8 mm LED neon flex. Compare its three V2 catalogue configurations, each listed with a 24 V supply and 50 mm cutting interval.

Connect the Profile to the Installation

Signage & outlines

Share the installation section, intended viewing position, light appearance and cable route.

Explore the application

Architectural curves

Share the installation section, intended viewing position, light appearance and cable route.

Explore the application

Display details

Share the installation section, intended viewing position, light appearance and cable route.

Explore the application

Mounting & End Connections

End caps, cable exits, rigid aluminum profiles and bendable supports are selected around the actual section. Accessory compatibility should be confirmed against the selected profile before quotation.

Use the exact profile and configuration when discussing your project. The International Catalogue contains the complete model rows; accessory documents support a separate fit review.

Custom Profile Development

White silicone profile being checked at extrusion tooling during a production trial
Silicone profile at extrusion tooling during a production trial. This photograph does not establish equipment capacity or a model-specific test result.

From an Existing Profile to a Custom Detail

Start with a catalogue profile when its section fits. If the groove, emitting face, strip space or end interface needs a different geometry, send a drawing, installation sketch or physical sample for custom silicone extrusion review.

New Profile Configurations

Real illuminated linear lighting assemblies arranged for production review

Review the Profile for Your Project

Send the profile size, required light appearance, installation route and quantity. We will review the exact configuration and mounting details.

Request a Quote